Cleaning Fiberglass Tub After Installation

Remove any loose debris from surface.

Run tub full of warm water and mild detergent as hand dishwashing liquid or laundry detergent; soak for 1/2 to 1 hour; drain and rub surface with sponge, rag, or non-abrasive applicator; rinse thoroughly.

If grease, oil, tar stains:

Spray with home laundering spray pre-wash; rub lightly with sponge or non-abrasive applicator; rinse.

If ceramic adhesives or paints:

Follow solvent methods above under "tough stains".

This article does not necessarily reflect the views of 411 Home Repair, and is only a suggestions and/or comments submitted to our site to share with our site viewers through the world wide web.

Submitted by: Michigan State University

Click Here if you would like to submit an article.